This is a ventilation fan that was specially modified to reduce the noise compared to an untreated fan, plus it comes with a noise canceling sleeve and flexible air duct to direct air into your vocal booth.
This product is specially designed for voice over actors to deliver fresh air into your vocal booth in between sessions. It works well with our soundproof booths or any DIY sound booth.
The 6 inch ventilation fan delivers approximately 240 CFM (cubic feet per minute) of air and it is hardly audible at the microphone level inside the booth, by incorporating the Fan Speed Controller.
The ventilation fan is 6 inches wide. The outlet is 4 inches wide. The noise cancelling sleeve is about 12-14 inches long.
Every element of the fan was crafted to maximize noise reduction. Blades are treated to reduce noise of the Ventilation fan. Special case reduces vibrations by the fan motor. Sound absorption sleeve reduces the noise of the air passing through it. Flexible Air duct allows you direct the air flow inside the booth to where you need it most.
The fan is designed to be placed OUTSIDE the booth with muffler going from the fan into the booth. The fan is set up to blow air into the booth, but the motor can be reversed and the system can be set up to draw the air OUT of the booth, further reducing the noise level.
Includes Fan, Muffler, flexible Air Duct. This product is ready to work right out of the box!
NOTE: Even though this fan is very quiet it may be a good idea to turn it off when recording.
***(setup comes with the inside chamber ring flattened for shipping, you would need to put your arm inside the muffler from the fan side and twist the ring into place, covering the opening to the output tube, allowing the chamber to expand, air to flow freely)***
Made in the USA.